Atributy
- Caliber:
9.3 mm (.366)
- Dodací hmotnost: 0,023kg
- Šířka přepravy: 83mm
- Délka přepravy: 146mm
The Sinclair Chamber Length Gage is an essential tool for handloaders looking to ensure the perfect fit for their rifle's chamber. This 9.3MM chamber length gage allows you to accurately measure the length from the bolt face to the end of the chamber's neck.
Understanding the differences between published trim lengths and your actual chamber length is crucial. You might be over-trimming your cases by as much as .030 inch or more, which can affect performance.
Important Notes:
Ensure your reloading process is precise and effective with the Sinclair Chamber Length Gage.
9.3 mm (.366)
5.56 NATO gaged Chamber length new DPMS 10.9.2016
Followed instructions as provided and measured the chamber 3 times and the length came out exactly 1.781 on the chamber. Knowing this I will size all my Lake City brass to 1.771. Which is where the vast major of measures to any way. Now I have confidence in my reloads thanks to this marvelous little cheap gage. I will keep all my brass separate and will use the 1.771 brass for match shooting and everything else for plinking.
Worked great 24.12.2015
I had no trouble making a case to accept this gauge. I'm not sure why so many reviewers had difficulties. To make this easier for you gents, trim a re-sized case to 1.640 then insert the gauge. Yes, the case looks short and only has a little bit of neck left, but it works great!
One thing I would change about the directions....it says to drill out the flash hole to make access to push the gauge back out. This is not needed. I used a kinetic bullet puller to "lengthen/re-set" the case with gauge installed. It only needs to be lengthened by 10 thou between uses.
Narazili jsme na chybu při načítání obsahu. Obnovte stránku a zkuste to znovu. Pokud problém přetrvává, kontaktujte naši zákaznickou podporu.