Top takeaways
- Secure case alignment
- Efficient trimming process
- Compatible with Q-Style holders
Atributy
- Case Type: Fired
- Náboje: 45 Auto (ACP)
- Dodací hmotnost: 0,068kg
- Výška přepravy: 28mm
- Šířka přepravy: 28mm
- Délka přepravy: 53mm
Produkt č.: 749002536
Výrob. č.: PH-45A
Držáky nábojů Wilson drží náboj kolmo na čelní stranu nože pro ořezávání, stejně jako pro vnitřní vyvrtávání krčku, odhrotování ústí náboje a odstraňování vojenského zajištění. Standardní držáky nábojů pro pistole vyžadují, aby byly náboje pevně zatlačeny do držáku, aby byly bezpečně uchyceny díky konstrukci se svislými stěnami. Doporučujeme používat držáky Q-Style, pokud jsou k dispozici, pro náboje pistolí.Used to make Makarov Brass 27.6.2015
I used this Wilson holder to turn 9mm luger into 9mm Makarov. Used a drill to speed things up. Obviously, you size to Makarov after you trim to about 18mm (exact trim to length in your load book).
Works great. Creates a mess of course. I had to create a system where I would hammer out the piece of brass by using a brass punch. One quick tap to the holder would knock it out. It's not like the rifle brass which can be knocked out quickly. Wilson warns of this in the instructions with this holder.
Works when it is used correctly 30.4.2015
I have accurately cut many cases using this without using a press. As long as the back of the cartridge extends out of the holder to where the micro-meters foot can make contact with it and the cutting bit can make contact with the case edge you are golden. This will make a consistent cut time after time as it is a set distance based on the cartridge. if the cartridge does not extend out the back of the holder your micro-meter foot will contact the holder and will cut the case too short. My only gripe is that the holder has a tenancy to spin in the trimmer when the cutter is pressed harder to cut faster.
Narazili jsme na chybu při načítání obsahu. Obnovte stránku a zkuste to znovu. Pokud problém přetrvává, kontaktujte naši zákaznickou podporu.