Atributy
- Caliber:
243/6 mm (.243)
- Dodací hmotnost: 0,068kg
- Výška přepravy: 30mm
- Šířka přepravy: 36mm
- Délka přepravy: 86mm
- UPC: 815145023124
Produkt č.: 749004350
Výrob. č.: INR-060
815145023124 Silné krky mohou způsobit vysoké tlakové hodnoty v komoře a nepravidelnou střelbu. Wilson neck reamers odstraňují přebytečný materiál z krku, aby byla zajištěna dostatečná vůle mezi krkem náboje a komorou. Tyto reamery lze také použít při formování wildcat nábojů z mateřského pouzdra. Reamery se používají v Wilson trimeru místo trimerového nože. Standardní reamery jsou velikostně přizpůsobeny pro použití na vystřelených, neopracovaných nábojích a měří .0025" - .003" větší než průměr projektilu. Na zakázku vyráběné reamery mohou být broušeny (doba dodání 6-8 týdnů).Dodací lhůta je přibližně 14-21 dní.
WILSON NECK REAMER, 6MM (0.2455"-0.246") INSIDE NECK REAMER is designed to enhance your shooting experience by ensuring proper chamber clearance.
Thick necks can lead to high chamber pressures and unpredictable shooting patterns. The Wilson neck reamers effectively remove excess neck material, providing adequate clearance between the case neck and the chamber.
These reamers are also invaluable when forming wildcats from a parent case. They are utilized in the Wilson trimmer, replacing the standard trimmer cutter.
Ensure your firearm's performance and reliability with the WILSON NECK REAMER!
243/6 mm (.243)
Works well if used correctly 30.1.2017
The standard reamer is not made to remove doughnuts. Standard size reamers are to be used on FIRED cases that have been reloaded several times and have material build up in the case neck they finish out at about .002" over bullet diameter. If you are looking to remove the doughnut with the Neck Reamer make sure you order a special diameter reamer. Sinclair stocks several special sizes. If the reamers are used correctly, they can be very useful in resolving several different issues in the case necks.
Will Not Remove Neck "Donuts" 15.5.2015
I purchased this inside neck reamer to remove case neck donuts in my 6xc brass (formed from 22/250 brass). Many people recommended inside neck reaming as the best way to remove the donuts and said that Wilson's inside neck reamer was the best available. Unfortunately it won't cut through the donut and jams solidly when it hits it. The donuts are just too tough for the reamer. Unfortunately I have wasted my money on this product for the purpose of removing case neck donuts. If you have the dreaded donut problem look for another solution.
Narazili jsme na chybu při načítání obsahu. Obnovte stránku a zkuste to znovu. Pokud problém přetrvává, kontaktujte naši zákaznickou podporu.