EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with the mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Vylepšete svůj Taurus G2/G3 s EGW Sight Mount!
EGW red dot sights jsou navrženy k instalaci zleva doprava (s hlavní směřující vpřed). Dovetail má progresivní zúžení, které usnadňuje instalaci. Jednoduše odstraňte zadní mířidlo na vaší zbrani a nahraďte ho montáží, abyste mohli připevnit svůj Vortex Viper/Venom, Burris FastFire nebo Docter red-dot sight. Montáž lze kdykoli odstranit a zadní mířidlo opět nainstalovat. Montážní hardware je součástí balení.
Pokyny k instalaci
- Odstraňte zadní mířidlo*
- Nainstalujte EGW Sight Mount do dovetailu
- Utáhněte set screw (pokud je to relevantní)
- Položte red dot sight na EGW Sight Mount (položení malého kousku papíru mezi red dot sight a sight mount usnadní odstranění a zabrání Loctite na red dot sight).
- Naneste modrý Loctite na dodané montážní šrouby
- Utáhněte montážní šrouby na 15in/lbs
Obsah balení:
- 2 Button Head Cap Screws - poskytnuto pro Vortex Viper a Venom Sights
- 2 Flat Head Cap Screws - poskytnuto pro Burris FastFire a Docter Sights
Šrouby, které jsou součástí této montáže, vyžadují pro instalaci imbusový klíč o velikosti 5/64''.
Úprava vaší zbraně může zrušit záruku výrobce.
Tento produkt by měl být nainstalován a zkontrolován kvalifikovaným zbrojířem.
Žádná odpovědnost není vyjádřena ani implikována za škody nebo zranění, které mohou vzniknout nesprávnou instalací nebo použitím tohoto produktu.