Atributy
- Model:
700
,721
,722
- Typ zbraně:
Remington
- Dodací hmotnost: 0,005kg
- Výška přepravy: 10mm
- Šířka přepravy: 69mm
- Délka přepravy: 142mm
700,
721,
722
Remington
Produkt č.: 969000173
Výrob. č.: 33240
Zvyšte výkon své pušky Remington s těmito snadno instalovatelnými pružinami. Pružina s nižší silou (RP) pomáhá snížit pociťovanou sílu spouště pro lepší a konzistentnější přesnost.Dodací lhůta je přibližně 14-21 dní.
Udělejte krok k lepší přesnosti s pružinou spouště WOLFF pro Remington 700/721/722. Tyto pružiny jsou snadno instalovatelné a přináší výrazné zlepšení výkonu vaší pušky.
Pružina s nižší silou (RP) pomáhá snížit pocitovou sílu spouště, což vede k lepší a konzistentnější přesnosti. Ideální volba pro každého, kdo hledá optimalizaci svého střeleckého zážitku.
Vylepšete svou střelbu a získejte lepší kontrolu nad každým výstřelem díky pružině spouště od WOLFF!
700,
721,
722
Remington
Junk 23.12.2017
The factory spring allowed minimum of 4 lbs. This spring was shorter and stiffer than the factory spring. 6lbs was as low as you could go before the set screw no longer contacted the spring and the rifle became unsafe. Save time and money and go another route.
Helps a little 26.7.2015
Because Wolff's customer service is not knowledgeable about this product, I ended up going to another company's web site for installation instructions. This spring is NOT the one that goes behind the trigger. DO NOT try to remove the one that goes behind the trigger, and which is tensioned by the screw in the trigger. It goes in the front of the trigger housing assembly. You will need to remove the factory installed sealant to remove the screw that holds this spring in. Also, it is not as long as the one pictured here. It is about 1/3 that length. Trigger pull was reduced to about 3.5 # with this spring installed. That was on a gun that REMINGTON could not (or would not) reduce below 5 #. I sent two NEW rifles back to Remington because of heavy trigger pull. Despite the fact that the hang tag on the brand new guns states, "3 1/2 pounds out of the box" , Remington was unable to actually bring the guns into spec. The guns were returned to me with a heavy trigger pull, and a note explaining that they adjusted to 4.5# and 5.5 #, NOT 3.5. This spring helped, but keep in mind you will need to void the Remington warranty to bring it into Remington spec.
Narazili jsme na chybu při načítání obsahu. Obnovte stránku a zkuste to znovu. Pokud problém přetrvává, kontaktujte naši zákaznickou podporu.