Atributy
- Náboje:
10 mm Auto
- Style:
Pistolové zápalky
- Dodací hmotnost: 0,068kg
- Výška přepravy: 15mm
- Šířka přepravy: 18mm
- Délka přepravy: 130mm
Produkt č.: 184051410
Výrob. č.: F10MMAUTOB
Vyrobeno firmou Clymer, skutečně oddanou skupinou gun lidí, z nejkvalitnější oceli M-7 High-Speed. Tyto jsou přesné nástroje pro profesionální zbrojíře a poskytnou dlouhou životnost, pokud jsou řádně udržovány. Plně zaručeno. Hrubé reamery jsou o .010" menší v průměru než konečná velikost, neřezají do oblasti krku a měly by být používány k úspoře opotřebení na Finisher Reameru, když má být vyříznuto mnoho komor. Pokud má být vyříznuto pouze několik komor, stačí pouze Finisher Reamer. Vynikající kvalita reamerů vyrobených podle specifikací SAAMI.Dodací lhůta je přibližně 14-21 dní.
Introducing the PISTOL CHAMBERING REAMERS, RIMLESS FINISHER STYLE REAMER FITS 10MM AUTO BARREL by CLYMER. These high-quality reamers are designed to cut accurate chambers for rimmed, rimless, and rimfire handgun cartridges.
Made by Clymer, a dedicated group of gun enthusiasts, these tools are crafted from the finest M-7 High-Speed Steel. They are precision instruments for professional gunsmiths and will provide a lifetime of service when properly maintained. Each reamer is fully guaranteed.
Roughers are .010" smaller in diameter than the final size, do not cut the throat area, and should be used to minimize wear on the Finish Reamer when multiple chambers need to be cut. If only a few chambers are to be cut, a Finish Reamer is all you require. These reamers are made to SAAMI specifications, ensuring superb quality.
When placing an order, please provide the following:
10 mm Auto
Pistolové zápalky
Great for reworking tight chambers. 4.8.2015
I used this to correct a 40 S&W barrel that had an undersized chamber and rough throat. The finish produced is outstanding. Can be used by hand with a tap wrench and good cutting oil like Do-Drill. Just cut a few turns, back out while still spinning, wipe or blow off chips, re-oil and go again. Use extreme care when you are getting close to shoulder area so you just clean up the shoulder. If you have depth mikes, check the headspace depth so as not to exceed SAAMI specs which can be printed off the SAAMI website for free.
Very nice reamer 1.11.2009
Not much you can say about a reamer. It's very clean,very sharp and over all nice grinding.
Narazili jsme na chybu při načítání obsahu. Obnovte stránku a zkuste to znovu. Pokud problém přetrvává, kontaktujte naši zákaznickou podporu.