EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Please take note to the Pre 2017 and Post 2017 differences. Pre 2017 rear shelf behind the dovetail is .187"" and Post 2017 is .120".
Vynikající montáž pro puškohledy Vortex Viper/Venom na Desert Eagle Pre 2017!
Montáž EGW pro puškohledy Vortex Viper/Venom je navržena tak, aby se snadno instalovala na vaši zbraň Desert Eagle Pre 2017. Tento produkt je ideální pro ty, kteří chtějí vylepšit přesnost a rychlost zaměřování.
Popis produktu
EGW red dot sights jsou určeny k instalaci zleva doprava (s hlavní směřující vpřed). Dovetail má progresivní zkosení, které usnadňuje montáž. Jednoduše odstraňte zadní mířidlo na vaší zbrani a nahraďte ho montáží EGW, abyste mohli namontovat váš Vortex Viper/Venom, Burris FastFire nebo Docter red-dot sight. Není potřeba žádných úprav. Montáž můžete kdykoliv demontovat a vrátit zpět zadní mířidlo. Montážní hardware je součástí balení.
Pokyny k instalaci
- Odstraňte zadní mířidlo*
- Instalujte montáž EGW do dovetailu
- Utáhněte šroub (pokud je to relevantní)
- Umístěte red dot sight na montáž EGW (umístění malého kousku papíru mezi red dot sight a montáž usnadní demontáž a ochrání red dot sight před Loctitem)
- Naneste modrý Loctite na dodané montážní šrouby
- Utáhněte montážní šrouby na 15in/lbs
Obsah balení
- 2 Button Head Cap Screws - poskytnuto pro Vortex Viper a Venom Sights
- 2 Flat Head Cap Screws - poskytnuto pro Burris FastFire a Docter Sights
Šrouby, které jsou součástí této montáže, vyžadují klíč o velikosti 5/64'' pro instalaci. Upozorňujeme na rozdíly mezi Pre 2017 a Post 2017. Zadní police za dovetailem Pre 2017 má rozměr .187" a Post 2017 je .120".