Atributy
- Style: Press Type
- Dodací hmotnost: 0,032kg
- Výška přepravy: 20mm
- Šířka přepravy: 61mm
- Délka přepravy: 99mm
- UPC: 611760116995
Produkt č.: 749000250
Výrob. č.: 11699
611760116995 Sada pěti držáků nábojnic Redding je navržena tak, abyste mohli upravit svůj headspace výběrem vhodné tloušťky držáku nábojnic Redding. Pět držáků nábojnic je o +.002", +.004", +.006", +.008" a +.010" silnější než běžné držáky nábojnic (.125" od spodní části nábojnice po vrchol držáku). Každý držák je jasně označen a má černý oxidový povrch, který je odlišuje od běžných držáků. Dodává se v balení s úložným boxem pro 6 pozic, přičemž zůstává prázdné místo pro váš běžný držák. Zobrazit tabulku držáků nábojnic Redding.Redding’s five piece shellholder set je navržen tak, abyste mohli upravit svůj headspace výběrem vhodné tloušťky Redding shellholderu. Tento set obsahuje pět shellholderů, které jsou +.002", +.004", +.006", +.008" a +.010" silnější než normální shellholdery (0.125" od spodní části hlavy náboje po vrchol shellholderu).
Pro více informací si prohlédněte Redding Shellholder Chart.
Useless Waste of Money 26.1.2017
Following the directions, and using with a Redding press and die, I was unable to bump identical brass with any consistency whatsoever. I did not find this product useful at all, and it's grossly overpriced for a set of shell holders. Should be about $20 even if they are useful to you. I love made in the USA, and Redding is a good company, but I returned this product.
Make cartridge headspace easy 25.12.2010
The best accuracy a centrefire rifle can deliver usually requires hand-loaded ammunition that precisely fits the chamber. A Redding Competition Shellholder Set used with a Redding Body Die or FLS die provides a simple and straight forward method of resizing fired cases to neatly fit the chamber with a practical minimum of 0.001" to 0.002" of headspace clearance. For the most consistent results, use a good quality sizing lube such as Imperial Wax. Operate the press handle slowly when resizing, and allow the case to experience the full pressure of resizing for a few seconds at the top of the ram stroke. Cartridges properly prepared for hand-loading using this approach will chamber snugly and without resistance with the axis of the cartridge centrally aligned with the bore.
Narazili jsme na chybu při načítání obsahu. Obnovte stránku a zkuste to znovu. Pokud problém přetrvává, kontaktujte naši zákaznickou podporu.