RCBS Coated Neck Bushings are interchangeable to let the reloader select a bushing that gives precisely the right amount of tension on the bullet when using RCBS Gold Medal Match neck sizing dies. These bushings have a Tungsten Disulfide (WS2) anti-friction coating, so they do not require use to traditional case lube. Self-centering for proper alignment with case neck For best results, use of high-end brass with consistent neck thicknesses For use ONLY with RCBS Gold Medal neck sizing dies RCBS recommends having neck bushings one to two sizes above and below your target diameter (see note below). RCBS Coated Neck Bushings are a small but critical component in loading extremely consistent-shooting ammo with your Gold Medal Match sizing dies. Brownells Gun Tech™ Tip: There are two ways to select the steel neck bushings you need: (1) Measure the outside neck diameter of your loaded cartridge and subtract .002" to .003". This allows approximately .001" of brass to spring back for correct neck tension. (2) You can also measure the neck wall thickness of your case, multiply by two, add the diameter of your bullet and subtract .002" to .003".
Vylepšete svůj střelecký výkon s našimi bushingy pro velikost krku!
RCBS Coated Neck Bushings jsou zaměnitelné a umožňují reloadérům vybrat si bushing, který poskytuje přesně správné množství napětí na projektil při použití RCBS Gold Medal Match neck sizing dies.
Vlastnosti produktu:
- Tungsten Disulfide (WS2) anti-friction coating – nevyžaduje použití tradičního lubrikantu na náboje.
- Samocentrování pro správné zarovnání s krkem náboje.
- Pro nejlepší výsledky doporučujeme používat vysoce kvalitní mosaz s konzistentní tloušťkou krku.
- Pouze pro použití s RCBS Gold Medal neck sizing dies.
- RCBS doporučuje mít neck bushings o jednu až dvě velikosti nad a pod cílovým průměrem.
RCBS Coated Neck Bushings jsou malou, ale kritickou součástí pro výrobu velmi konzistentních nábojů s vašimi Gold Medal Match sizing dies.
Tip od Brownells Gun Tech™:
Existují dva způsoby, jak vybrat potřebné ocelové neck bushings:
- Změřte vnější průměr krku vašeho nabitého náboje a odečtěte .002" až .003". To umožní přibližně .001" mosazi vrátit se zpět pro správné napětí krku.
- Můžete také změřit tloušťku stěny krku vašeho náboje, vynásobit dvěma, přidat průměr vašeho projektilu a odečíst .002" až .003".