Brownells Česká republika - Světově největší dodavatel součástek zbraní, zbrojního vybavení a příslušenství. Česká republika

SINCLAIR INTERNATIONAL
SINCLAIR STUCK CASE REMOVAL TOOL

749013572
We developed this handy tool to help solve the reloader’s age-old nightmare; removing a case stuck in the sizing die. This happens when the rim of the case tears off during the downstroke, leaving the case body in the die, with nothing to grab to pull it out. The Sinclair Stuck Case Removal Tool lets you clear that stuck case from any standard sizing die without risk of damaging the die. Just remove the die from the press and back out the decapping pin until it’s out of the flash hole. Clamp the die in a vise and “thread” the primer pocket and flash hole using the included drill and tap, so you can screw the main body of the tool into the hole. As you tighten the cap screw with a standard 3⁄16" hex head wrench, the tool neatly pulls the case out of the die.
799 799 1 CZK
Produkt č.: 749013572
SINCLAIR INTERNATIONAL STUCK CASE REMOVER Vyvinuli jsme tento praktický nástroj, který pomáhá překonat noční můru každého přebíječe; odstranění nábojnice, která uvízla ve formě pro přebíjení. K tomu dochází, když se během stlačování odtrhne okraj nábojnice, čímž zůstane tělo nábojnice ve formě bez možnosti uchopit a vytáhnout ji ven. Nástroj Sinclair Stuck Case Removal Tool vám umožní bezpečně odstranit uvízlou nábojnici z jakékoli standardní formy pro přebíjení, aniž byste poškodili formu. Stačí vyjmout formu z lisu a vyšroubovat vyhazovací kolík, dokud není mimo otvor pro zápalku. Formu upněte do svěráku a pomocí dodaného vrtáku a závitníku „nastavte“ zápalkový otvor a otvor pro zápalku, abyste mohli hlavní část nástroje zašroubovat do otvoru. Jakmile začnete utahovat šroub pomocí standardního šestihranného klíče 3⁄16", nástroj elegantně vytáhne nábojnici z formy.
799 CZK 0 799,00 Kč *
Předbjednávka, dodací lhůta je přibližně 4-12 týdnů ze skladu z USA.

Atributy

Dodací hmotnost: 0,126kg Výška přepravy: 13mm Šířka přepravy: 102mm Délka přepravy: 152mm

Detail produktů

Made in USA



We developed this handy tool to help solve the reloader’s age-old nightmare; removing a case stuck in the sizing die. This happens when the rim of the case tears off during the downstroke, leaving the case body in the die, with nothing to grab to pull it out. The Sinclair Stuck Case Removal Tool lets you clear that stuck case from any standard sizing die without risk of damaging the die. Just remove the die from the press and back out the decapping pin until it’s out of the flash hole. Clamp the die in a vise and “thread” the primer pocket and flash hole using the included drill and tap, so you can screw the main body of the tool into the hole. As you tighten the cap screw with a standard 3⁄16" hex head wrench, the tool neatly pulls the case out of the die.
Novinky