Pre-machined aluminum pillars solve the difficult problem of bedding Ruger bolt action centerfire rifles. The front pillar is cut to match the 60 degree angle of the receiver screw; pre-notched with the correct contour and angles to fit against the bottom of the recoil lug and set square with the floorplate hinge. Fits all Ruger® 77 and M77® Mark II™ rifles except VT target models.
SPECS: Aluminum, natural finish. Front - .600" (15.2mm) long, .535" (13.6mm) dia. Rear - 1.145" (2.9cm) long, .535" (13.6mm) dia.
Předem opracované hliníkové sloupky řeší složitý problém usazení pušek Ruger s předovkou. Přední sloupek je řezán tak, aby odpovídal 60stupňovému úhlu šroubu závěru; předřezaný s odpovídajícím profilem a úhly, aby se vešel proti spodní části zpětného klínu a byl kolmo na závěsný kloub spodní desky. Pasuje na všechny pušky Ruger® 77 a M77® Mark II™ kromě modelů VT pro soutěže.
TECHNICKÉ ÚDAJE: Hliník, přírodní povrch. Přední - .600" (15.2mm) dlouhý, .535" (13.6mm) průměr. Zadní - 1.145" (2.9cm) dlouhý, .535" (13.6mm) průměr.