Atributy
- Dodací hmotnost: 0,091kg
- Výška přepravy: 38mm
- Šířka přepravy: 97mm
- Délka přepravy: 394mm
- UPC: 090255704174
Hornady Lock-N-Load OAL Gauge (dříve Stoney Point) je extrémně snadno použitelný nástroj. Stačí jen pár minut na to, abyste zjistili celkovou délku pro konkrétní projektil.
Nástroj je na jednom konci závitový, aby bylo možné použít speciálně upravené náboje. Jakmile je náboj nasazen na nástroj, vložíte projektil do náboje. Následně se nástroj zasune do komory vaší pušky. Píst na nástroji se používá k tlačení projektilu proti drážkování. Poté se tyč uzamkne na místě a nástroj lze vyjmout z pušky.
Pak změříte vzdálenost mezi základnou náboje a vrcholem projektilu pomocí svých měřicích kalibrů (v tomto okamžiku se velmi doporučuje použití komparátoru projektilů) k získání OAL. Pokud chcete zkontrolovat jiný typ projektilu, vložte nový projektil do nástroje a postup opakujte.
Oba modely využívají stejné upravené náboje. Tento nástroj je vynikající pro pravidelné kontrolování eroze ústí hlavně pušky. Skvělý pro kontrolu použitých pušek. K dispozici je více než 60 různých upravených nábojů, které lze s tímto nástrojem použít.
Get the straight one instead 1.11.2017
I bought this for an AR-15 and figured it would be the ideal for any future guns since the description says it'll work on autoloaders.
Unfortunately the design falls short. Thankfully Brownells has a great return policy and I got a straight one that works much better.
The "push rod" of the curved model is a tightly wound spring that is bigger than the trench cut in the oal gauge body so that the push rod protrudes past the machined relief that a caliper's jaw is meant to rest against. This prevents the caliper jaw from laying flat and pushes the round too far away from the bullet comparator set that you want to get with this tool for best measurements.
That bullet ogive comparator set is designed with the required offset for the straight OAL tool to line the case & bullet up perfectly with the comparator bullet hole but the additional forced offset of the curved tool means the case is not lined up square with the comparator bullet hole and instead presents the bullet a few degrees off of straight so that a precise measurement is impossible.
Bottom line: Get the straight version unless you have a rifle that will not allow it to work like a lever gun or just hate precise measurements.
I tried adding some photos but the server would not let me on this item for some reason even though I've done it elsewhere.
Works great for precision reloading. 30.10.2017
I use this to determine the distance to lands in an AR-15 for greater than magazine length loads using Sierra Match King 80gr bullets that are single loaded. It's a great way to enhance accuracy when done right.
The only headache is getting repeatable measurements on the distance to lands because of the shape of some leades (tapered start of rifling). Take your time, try different insertion methods and keep at it until you can get 10 consistent readings. At my best I'll get 10 readings with only .001" difference between them.
The photo below shows a 3 round group in the top right corner of the target I fired at 680 yards after the two in the center and one low left.
Narazili jsme na chybu při načítání obsahu. Obnovte stránku a zkuste to znovu. Pokud problém přetrvává, kontaktujte naši zákaznickou podporu.